Watlow Electric Silver Series Guide d'installation télécharger pdf (Page 14)

14 Watlow Silver Series OIT Installation Guide

surface is not uniform, thick, flat, stiff, or smooth enough, then a sealant

such as silicone may be required.

NOTE: Clean and deburr the panel cutout before the OIT is installed.

Warning: The OIT requires a stiff, flat, smooth mounting

surface free of blemishes to seal properly to NEMA 4. All

supplied mounting clamps must be used and the panel cannot

flex more than 0.010”.

Mount the OIT to the Panel

Figure 5: Installing Screw Clamps to the OIT

Note: The clamps for your model may be slightly different than shown

here, but essentially work in the same way.

STEPS:

1. Prepare the clamps for the OIT by inserting the screws into the

clamp as shown above. Position the screws so that the ends don’t

protrude through the clamp’s hole.

0600-0101-0000 Rev A

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Watlow Electric Silver Series Guide d'installation Page 14